Ei Professional Smoke Alarms and Smoke Detectors

Battery Powered Smoke and Heat Alarms

Applications

Sealed in battery is designed to last up to 10 years – so there are no batteries to replace, ideal for low maintenance applications. Also available as an interconnect unit

Main Features

Lithium 10 year batteries to provide long lasting life

On interconnect version (Ei 100TYC) – interconnect up to 12 other alarms

High sensitivity – responds to all standard fires

Dual ionisation chamber – quick response to fast flaming fires

Battery powered – 9 volt (supplied)

Built in sounder to give a minimum sound output of 85dB(A) at 3m

Warning system when batteries have expired and unit needs replacing

Easily installed – no wiring

Test Button simulates smoke – use to check performance at least monthly

Hush Button – silences nuisance alarms

5 year guarantee (limited)

Installation

For full Installation and Siting Instructions please refer to the Use and Care Manual

This Alarm is battery operated and needs no wiring, except when interconnecting

Pull cover open at Tab. Remove cover from base by separating at rear snap-in hinges

Place the base on ceiling or wall exactly where you want to mount the unit. With a pencil, mark the location of the screw holes

Taking care to avoid any electrical wiring in the ceiling or wall, drill a hole through the centres of the marked locations. Push the plastic screw anchors provided into the drilled holes. Screw in firmly

Push the power-on button until it clicks to connect the battery permanently. You may hear a loud chirp when pressing the button – this is normal

Trouble Shooting

Nuisance/False Alarms occur:

If, when the alarm goes off, there is no sign of smoke, heat or noise to indicate that there is a fire, you should get your family into a safe place, before you start investigating

Check the house carefully in case there is a small fire smouldering somewhere

Check whether there is some source of smoke or fumes, for example cooking fumes being drawn past Smoke Alarm by extractor

If there are frequent nuisance/false alarms it may be necessary to re-locate the device away from the source of the fumes

Fanning vigorously with a newspaper or similar will help silence alarm

This Smoke Alarm is designed for more difficult areas, as you can silence the alarm for about 10 minutes. This gives time for smoke or fumes to clear

Back to Top